The ZCU102 Evaluation Kit enables designers to jumpstart designs for Automotive, Industrial, Video and Communications applications. This kit features a Zynq UltraScale+™ MPSoC device with a quad-core ARM® Cortex-A53, dual-core Cortex-R5 real-time processors, and a Mali-400 MP2 graphics processing unit based on Xilinx's 16nm FinFET+ programmable logic fabric. The ZCU102 supports all major peripherals and interfaces enabling development for a wide range of applications.

• Optimized for quick application prototyping with Zynq Ultrascale+ MPSoC

• DDR4 SODIMM – 4GB 64-bit w/ ECC attached to Processor Subsystem (PS)

• DDR4 Component – 512MB 16-bit attached to Programmable Logic (PL)

• PCIe Root Port Gen2x4, USB3, Display Port & SATA

• 4x SFP+ cages for Ethernet

• 2x FPGA Mezzanine Card (FMC) interfaces for I/O expansion including 16 x 16.3 Gb/s GTH transceivers and 64 user defined differential I/O signals

Configuration

• Onboard JTAG configuration circuitry to enable configuration over USB

• Dual Quad-SPI flash memory

• Boot from SD card

Memory

• PS 4GB DDR4 64-bit SODIMM w/ ECC

• PL 512MB DDR4 component memory ([256 Mb x 16] devices) at 1200MHz / 2400Mbps DDR

• 8KB IIC EEPROM

• Dual 64MB Quad SPI flash

• SD card slot

Control & I/O

• 6x Directional Push Buttons (5x PL, 1x PS)
  

• DIP switches (8x PL)
  

• PMBUS & System Controller MSP430 for power, clocks, and I2C bus switching
  

• USB2/3 (MIO ULPI and 1 GTR)**

Expansion Connectors

• 2x FMC-HPC connectors (16 GTH Transceivers,  64 differential user defined signals)

• 2x PMOD headers

• IIC

Communication & Networking

• RGMII communications at 10, 100, or 1000 Mb/s. Serial GMII interface-supports a 1 Gb/s SGMII interface

• 4x SFP+ cage

• SMA GTH support (4x SMA Tx/Rx connectors)

• UART To USB bridge

• RJ45 Ethernet connector

• SATA (1 x GTR)**

• PCIe Gen2x4 Root Port**

Display

• HDMI video input and output (3 GTH)

• External Retimer device driving an HDMI output connector

• 9x GPIO user LEDs (8x PL, 1x PS)
  

• VESA DisplayPort 1.2 source-only controller supports up to two lanes of main link data at rates of 1.62 Gb/s, 2.70 Gb/s, or 5.40 Gb/s.

Clocking

• Programmable clocks

• System clocks, user clocks, jitter attenuated clocks
  

• 2x SMA MGT input clocks

Power

• 12V wall adapter or ATX

** Switch enables either PCIe Root Port OR SATA, USB2/3 & DisplayPort