Zynq UltraScale+ RFSoC ZCU111 Evaluation Kit
Product model : EK-U1-ZCU111-G
2019-01-09 Times of browsing: 5106- Product introduction
- characteristic
- Product specification
- Physical picture
- Resources
The Zynq® UltraScale+™ RFSoC ZCU111 Evaluation Kit enables designers to jumpstart RF-Class analog designs for wireless, cable access, early-warning(EW)/radar and other high-performance RF applications. This kit features a Zynq Ultrascale+ RFSoC supporting 8x 4GSPS 12-bit ADCs, 8x 6.5GSPS 14-bit DAC, and 8 soft-decision forward error correction (SD-FECs). Complete with ARM Cortex A53 and ARM Cortex-R5 subsystems, UltraScale+ programmable logic, and the highest signal processing bandwith in a Zynq UltraScale+ device, this kit provides a rapid, comprehensive RF Analog-to-Digital signal chain protoyping platform.
Zynq UltraScale+ RFSoC ZCU111 Evaluation Board with XCZU28DR-2FFVG1517E RFSoC
DDR4 Component – 4GB, 64-bit, 2666 MT/s, attached to Programmable Logic (PL)
DDR4 SODIMM – 4GB 64-bit, 2400 MT/s, attached to Processor Subsystem (PS)
Ganged SFP28 cage to support up to 4 SFP/SFP+/zSFP+/SFP28 modules
USB3, DisplayPort, and SATA
FPGA Mezzanine Card (FMC+) interface for I/O expansion including 12 x 32.75 Gb/s GTY transceivers and 34 user defined differential I/O signals
XM500 RFMC balun transformer add-on card with 4 DACs/ 4 ADCs to baluns 4 DACs/ 4 ADCs to SMAs
Configuration
Onboard JTAG configuration circuitry to enable configuration over USB
JTAG header provided for use with Xilinx download cables such as the Platform Cable USB 3/2
Dual Quad-SPI flash memory
Boot from micro-SD card
Memory
PS 4GB DDR4 64-bit SODIMM at 2400 MT/s
PL 4GB DDR4 64-bit Component (four 512 Mb x 16) at 2666 MT/s
Dual 2Gb Quad SPI flash
SD Card Slot
Communication & Networking
RGMII communications at 10, 100, or 1000 Mb/s
4x SFP28 (SFP, SFP+, zSFP, zSFP+) cage
UART To USB Bridge
RJ45 Ethernet connector
SATA (1 x GTR)
Display
VESA DisplayPort 1.2 source-only controller supports up to two lanes of main link data at rates of 1.62 Gb/s, 2.70 Gb/s, or 5.40 Gb/s
8x GPIO user LEDs
Expansion Connectors
FMC-HPC (Partial Population) connector (12 GTY Transceivers, 68 single-ended or 34 differential user defined signals)
2x PMOD headers
RFMC DAC/ADC plug-in card interface
Clocking
Programmable clocks
System clocks, user clocks, RF data converter clocks
SMA MGT input clock
Control & I/O
5X directional push buttons
8X DIP switches
PMBUS & system controller
USB2/3 (1 GTR)
Power
12V wall adapter or ATX